简体中文
English
新闻中心
-
Cleaning steps before installing the drive shaft
Before cleaning a transmission shaft, conduct a thorough visual inspection to identify surface contaminants, rust, or damage. Use a magnifying glass or bright l...Read more -
Environmental adaptability testing of drive shafts
Transmission shafts operate across a wide temperature range, from sub-zero climates to desert heat, requiring materials and designs that resist thermal-induced ...Read more -
Fatigue life assessment of drive shafts
Fatigue failure in transmission shafts occurs due to repeated stress cycles that exceed the material’s endurance limit, even when individual stress levels remai...Read more -
Torsional stiffness test of the drive shaft
Torsional rigidity measures a shaft’s resistance to twisting under applied torque, directly influencing drivetrain efficiency and durability. This property is q...Read more -
Calculation of the safety factor of the drive shaft
The safety factor (K) in transmission shaft engineering quantifies the margin between a component‘s ultimate strength and its operational stress levels. This di...Read more -
Weight control standard for drive shafts
Transmission shafts serve as critical components in automotive drivetrains, connecting engines to wheels while transmitting torque and rotational motion. Their ...Read more -
Dimensional tolerance of the drive shaft steps
Transmission shaft step tolerances typically follow ISO 286-2 standards, which define 28 tolerance classes from IT01 to IT18. For precision automotive driveshaf...Read more -
Confirmation of keyway specifications for the drive shaft
Transmission shaft keyway widths typically range from 2mm to 100mm, with common industrial applications using 4mm, 6mm, 8mm, and 12mm widths. For example, autom...Read more -
The dust-proof grade of the drive shaft is compatible
The Ingress Protection (IP) rating system, defined by IEC 60529 and GB/T 4208-2017, uses two-digit codes to quantify protection against solids and liquids. The ...Read more -
Accuracy requirements for the installation holes of the drive shaft
Transmission shaft installation holes typically require IT6-IT7 precision grades for diameter dimensions, with surface roughness values ranging from Ra0.8μm to ...Read more